AA-ELP-9906GMCub

Description:
Fits Silverado, Sierra, Tahoe, Suburban and Yukon

**Just the black 3D printed mount and mount hardware included! NO Air Lift controller or AccuAir touchpad included.

It replaces the cubby next to your driver side AC vent.

4 screws will be included to match the air ride mount version you choose to secure your controller to the mount.

This mount is 3D Printed in PETG material and will withstand the heat in your ride. It is a direct replacement for the cubby part next to your driver door AC vent to house your AccuAir Touchpad. You will have to remove the trim bezel on the front of the dash first then pull the left ac vent/headlight switch panel out towards the rear of the truck. Its held in with clips. Then just pop out the cubby and replace with the new mount. The touchpad case comes not screwed in place...you will need to pop the new mount in place with the cord passed through the hole, then replace the dash trim bezel and last slide the case on the newly installed mount and put the one included 25mm screw to secure it toghether. Assembled in a manner that allows you to screw the 25mm screw from the steering wheel side of the mount. If you try to install the mount fully assembled you will see the dash trim bezel will NOT fit over the mount.

*3D printer layer lines are visible